TIA 1500 SIM project hardware

[DJM45]

Is it possible to change the 1500 hardware in the SIM template project?
I changed the CPU without issue. Now i’d like to add remote IO.
I would also like to remove the extra ai cards. I don’t need 3.

My project now goes into error - diagnostic buffer shows FC9000 (template) error.
Can anyone point me in the right direction?

TIA SIM TEST.zip (416.5 KB)
Test.factoryio (106.7 KB)

[DJM45]

Deleting or changing the address of any of the template cards in slots 2-5 renders an error in PLC SIM. Diagnostics point to FC9000.

This is what i’m stuck with at the moment.

I read this tutorial on how to configure my own Hardware config but it does not work for me.

S7-PLCSIM template projects

Communication between Factory I/O S7-PLCSIM only works with a specific set of settings and a custom function. Using Template Projects We provide ready to use project templates at the S7-PLCSIM section of the manual. You can also refer to a step-by-step guide on how to connect Factory I/O to S7-PLCSIM. Creating a project from scratch In case you need to create a new project from scratch the required settings are: Add the communication FB from one of our template projects. Make sure it runs. […

This is the config i require

[DJM45]

Can anyone help with my problem?